Audi SQ2 2.0 Stage 1 Remap
The latest generation 2.0TSI engine has seen some substantial changes in factory form to keep in line with the latest emissions laws. Most notable is the introduction of the GPF (Gasoline Particulate Filter) and the change to the single port injection system. Close monitoring of the GPF system has been an essential step in finding the limitations and tuning potential of the newer DNU* engines. The general consensus is that the GPF not only mutes but limits the engine power, Revo ECU calibration might be a reason to dispute that.
Enhancing the vehicle with Revo ECU Software gives you much more than just an increase in power and torque. A large part of development is based on drive cycle and driver feedback, our calibration doesn’t just give a great dyno curve and peak power/torque figures but also delivers in feel; giving a smoother yet more responsive feel at low RPM/ partial throttle with huge gains at wide-open throttle throughout the whole rev range.
Only Revo performance ECU Software maintains factory safety levels and additional driving features. You can switch between three pre-set fuel quality modes depending on the fuel you use; these modes are set through testing our development vehicles in varying climatic conditions with a range of fuel quality throughout the world. The Revo SPS Software Switch is also available separately, can be used to quickly switch between performance modes and access the additional Anti-Theft mode.
What’s included?
- Revo ECU Software (Optional TCU)
- Health Checks & Datalogging
- Air Intake Fitting (if required)
Recommended Upgrades
- Upgraded Air Intake System
Additional Features
Cold Start Protection Failure
For engine oil to work effectively and lubricate your engine it needs time to warm up. When you first start your car, the cold oil is at its thickest, producing higher oil pressure when pumped around the engine putting extra pressure on oil seals. As the engine temperature increases, so does oil temperature. This thins the oil, enabling it to run more freely and better lubricate the moving parts of your engine. Cold Start Protection helps protect engine components by limiting turbo boost based on RPM and oil temperature until it reaches the 80ºC optimum operating level.
Temperature Protection
Revo Temperature Protection is an additional safety feature that reduces overall load as the oil temperature passes a set limit. Exhaust gas temperatures (EGT) are also monitored, adapting the operating conditions (Air Fuel Ratio) to ensure they stay within safe parameters. If EGT’s reach a set upper limit, then power is automatically reduced until the engine returns to a safe operating temperature.
Switchable Software
Using the Revo SPS Software Switch you can take advantage of the multiple options in your ECU Software. The patented OBD2 interface is the ultimate compliment to Revo performance software, giving you the ability to switch between 3 fuel performance modes and an Anti-Theft mode.
- SPS Position 1 - Stock Mode
- SPS Position 2 - 97ron fuel / Regular torque for manual vehicles with stock clutches
- SPS Position 3 - 98ron+ fuel / Higher torque for DSG or manual vehicles with an uprated clutch.
- SPS Position 4 - Anti Theft
Simply select a program, plug in, wait a few seconds, remove the SPS device and start the car. It’s simple and there’s no fixed switch to install in the vehicle.
Antitheft mode
Revo Software is installed with a built-in Antitheft Mode, which is accessible with the Revo SPS Software Switch. This mode disables throttle response and limits RPM, adding an extra level of security to your pride and joy.
Compatibility
- Audi SQ2
Read More